R&D: Dependence of Growth Mode in Epitaxial FePt Films on Surface Free Energy

ACS Applied Materials & Interfaces has published an article written by Ippei Suzuki,National Institute for Materials Science, 1-2-1 Sengen, Tsukuba 305-0047, Japan, Shoichi Kubo, National Institute for Materials Science, 1-2-1 Sengen, Tsukuba 305-0047, Japan, Laboratory for Chemistry and Life Science, Institute of Innovative Research, Tokyo Institute of Technology, Yokohama 226-8503, Japan, and Department of Chemical Science and Engineering, School of Materials and Chemical Technology, Tokyo Institute of Technology, Meguro, Tokyo 152-8552, Japan, Hosein Sepehri-Amin, and Yukiko K. Takahashi, National Institute for Materials Science, 1-2-1 Sengen, Tsukuba 305-0047, Japan.

Abstract: “Epitaxial thin films of L1₀-ordered FePt alloys are one of the most important materials in magnetic recording and spintronics applications due to their large perpendicular magnetic anisotropy (PMA). The key to the production of these required superior properties lies in the control of the growth mode of the films. Further, it is necessary to distinguish between the effect of lattice mismatch and surface free energy on the growth mode because of their strong correlation. In this study, the effect of surface free energy on the growth mode of FePt epitaxial films was investigated using MgO, NiO, and MgON surfaces with almost the same lattice constant to exclude the effect of lattice mismatch. It was found that the growth mode can be tuned from a three-dimensional (3D) island mode on MgO to a more two-dimensional (2D)-like mode on MgON and NiO. Contact angle measurements revealed that MgON and NiO show larger surface free energy than MgO, indicating that the difference in the growth mode is due to their larger surface free energy. In addition, MgON was found to induce not only a flat surface as FePt grown on SrTiO₃ (STO), which has a small lattice mismatch, but also a larger PMA than that of STO/FePt. As larger lattice mismatch is favored to induce a higher PMA into the FePt films, MgO substrates are exclusively used, but 3D island growth is indispensable. This work demonstrates that tuning the surface free energy enables us to achieve a large PMA and flat film surface in FePt epitaxial films on MgO. The results also indicate that modifying the surface free energy is pertinent for the flexible functional design of thin films.“